PID Autotuning. BaseCam SimpleBGC 32bit, firmware 2.42
It is very important to have a gimbal proper prepared and calibrated. You will not get correct P,I,D parameters, and operability on gimbal that has flaws. For autotuning the system uses the same algorithm that was described in the blog on the BaseCam Electronics web site. For more details go to http://www.basecamelectronics.com/com...
▶︎
3 Axis Gimbal Auto Tuning PID Settings Alexmos SBGC Firmware Upgrade
▶︎
Alexmos simple bgc 32 bit 3 axis gimbal tutorial setting italiano
▶︎
Ghost Gimbal Calibrating Encoders
▶︎
SimpleBGC Wireless Configuration with Android App and Bluetooth
▶︎
ViiGim 503 - absolute Beginner - getting started - 3 axis gimbal - simpleBGC alexmos 32
▶︎
Подлючение энкодера AS5048 к оси YAW от AlexMos 32bit в стандартной прошивке.
▶︎
3 Axis Gimbal BaseCam SimpleBGC PID Tuning Question
▶︎
How to: Balance a mid size Gimbal
▶︎
Brushless Gimbals: Three reasons for why you want to have a 2nd IMU!
▶︎
How To - Calibrate 6 Point IMU Calibration 3 Axis Gimbal Stabilizer
▶︎
SimpleBGC: How the "Follow Frame" mode works
▶︎
Brushless Gimbal Handheld Setting method Part3
▶︎
How To: Configure Alexmos Gimbal
▶︎
3 Axis Gimbal Calibrating Camera IMU and Frame IMU 32 Bit Alexmos SBGC
▶︎
STorM32 3-axis brushless gimbal controller configuration / Настройка стабилизатора/ Прошивка Storm32
▶︎
VectorDD gimbal & Alexmos controller & AutoQuad flightcontroller
▶︎
Setup and tuning a 3-axis brushless gimbal
▶︎
Flexible Mechatronics
▶︎
32bit Alexmos V4.0 controller - Part 2 - roll/pitch config
▶︎