ART2K5TPUY Transistor Replace
This video shows how to replace one or both LDMOS transistors in a MK2, water cooled VK Amplifier by VK3AMP. Setting of the BIAS is done in the same way as the MHT1803 transistors except you will need to take note of where the GATE, DRAIN and GROUND is. BIAS should be set to draw 1AMP in each of the LDMOS transistors.
▶︎
2kW VK3AMP Transistor Replacement
▶︎
SPE EXPERT AMP LDMOS REPAIR VIDEO
▶︎
Most Ridiculous Worker Mistakes Caught on Camera
▶︎
Fender Just Lost Control
▶︎
5 Hi-Fi Speaker Brands Audio Technicians Actually Buy For Themselves
▶︎
Class D Amplifiers EXPOSED | Here's Why They're Accurate, Not Cold
▶︎
This Engine Breaks ALL the Rules
▶︎
Building circuits the hard way. An introduction to freeform electronics
▶︎
Dynaco ST-70 Original vs. VTA Bench & Listening Test Comparisons - Stereo 70 Tube Amp
▶︎
Revealing The SPECIAL TECHNIQUE Of A Pakistani Man To EXTRACT GOLD From Used Motherboard Waste
▶︎
23cm 600W PA, soldering of LDMOS devices
▶︎
TRUMP FURIOUS as BRIDGE BOYCOTT HITS US—CANADA DROPS 140-JET BOMBSHELL, TRUMP's OIL DREAM BLOWS UP
▶︎
RF-Kit B26 RF 2k Kit #6 Replacing the BLF189 LDMOS Chips and recalibrating
▶︎
Unbelievable Smart Worker & Hilarious Fails | Construction Compilation #8 #adamrose #smartworkers
▶︎
Keir Starmer resigns - this is what comes next | Varoufakis & Munchau | The Econoclasts
▶︎
Col Douglas Macgregor: Pressure to REMOVE TRUMP FROM OFFICE Growing
▶︎
What Happened to the Cox .049? | The Engine That Couldn’t Survive Modern Childhood
▶︎
NXP MRF300 RF Power LDMOS Transistors | Featured Product Spotlight
▶︎
The Rise and Fall of Simpson, The Analog Meter That Every American Technician Owned
▶︎