Подключение и настройка: цифровой (программируемый) терморегулятор - термостат w1209

#thermostat, #w1209, #thermostat Buy with a 7% discount (cashback after registration) - you can follow the link: http://alii.pub/5yhj6i Connecting the thermostat: 1) Connect a 12V DC power source to the contacts "+12V" (plus 12V) and "GND" (minus 12V). 2) Connect the load to the contacts "K0" and "K1" (connected in the break in the power supply circuit of the controlled device (serial connection)) Setting the controlled temperature: To set the control temperature, briefly press the "SET" button, then use the "+" or "-" buttons to set the desired temperature, and press the "SET" button again, or do not press any buttons for 5 seconds. Programming: To enter the programming mode, hold down the "SET" button for 5 seconds, then use the "+" or "-" buttons to select the menu parameter code Next, to set the parameter, press the "SET" button and use the "+" or "-" buttons to change the value of the parameter. To save the settings, press and hold the "SET" button, or do not press any buttons for 5 seconds. Thermostat menu: P0 - Thermostat operating mode: C - cooling (Cooling) / H - heating (Heating); P1 - Hysteresis, in the range from 0.1 ... 15 °C; P2 - Upper limit of the supported temperature setting, (110 max) °C; P3 - Lower limit of the supported temperature setting, (-50 min) °C; P4 - Temperature correction, -7 ... +7 °C; P5 - Relay on time delay (may differ from the selected one within ± 50%), range from 0 to 10 min. P6 - Upper limit of shutdown temperature (overheating protection), OFF or ON (at ON from 0°C to 110°C); P7 - Settings lock, OFF or ON; P8 - Reset settings.