산업안전지도사 2차 기출풀이 | 제16회 6번 - 가설공사 표준안전작업지침 (강관틀비계·통로발판·우회로) (제9조·제15조·제26조)

📝 Solutions to Past Exam Questions from the 16th Industrial Safety Instructor 2nd Round Exam (Essay Type Required) Q. Answer the following questions regarding the Standard Safety Work Guidelines for Temporary Construction. 1) List only 5 items that an employer must comply with when assembling and using steel pipe frame scaffolding. 2) List only 5 items that an employer must comply with when installing and using walkway platforms for temporary passageways. 3) List 5 items that an employer must comply with when installing a detour for a temporary road. ━━━━━━━━━━━━━━━━━━━━━━ ⏱️ Timeline 00:00 Intro 00:20 Problem Presentation 01:03 Sub-question 1) Steel Pipe Frame Scaffolding Intro (Article 9) 01:24 Sub-question 1) Full List (6 items) 02:10 Sub-question 1) Select 5 Key Items 02:32 Sub-question 2) Walkway Platform Intro (Article 15) 02:54 Sub-question 2) Full List (7 items) 03:35 Sub-question 2) Select 5 Key Items 03:57 Sub-question 3) Detour Intro (Article 26) 04:15 Sub-question 3) Full List (5 items) 04:45 Sub-question 3) Select 5 Key Items 05:03 Legal Basis 05:32 Summary of Key Points 06:15 Expected Questions 07:03 Outro ━━━━━━━━━━━━━━━━━━━━━ 📌 Answer Summary 1) Employer's Compliance Requirements for Assembling Steel Pipe Frame Scaffolding — 5 items (Article 9 of the Standard Safety Work Guidelines for Temporary Construction / Select 5 out of 6 relevant laws) ① Use base supports at the base of scaffolding columns (adjustable base supports in case of height differences) — Always maintain horizontal and vertical positions ② Total height must not exceed 40m / If exceeding 20m, main frame height must be within 2m and main frame spacing must be 1.8m or less ③ Install cross braces between main frames, and install horizontal members at the top floor and every 5 floors or less ④ Wall joints every 6m in the vertical direction and every 8m in the horizontal direction ⑤ Length in the tie beam direction must be 4m or less; if height exceeds 10m, install tie beam direction support columns every 10m or less ※ "Other matters shall be in accordance with steel pipe scaffolding" (Item 6) is a general provision — Select the 5 specific items above Write as Answer 2) Employer's Compliance Requirements for Installing Walkway Platforms — 5 Items (Article 15 / Select 5 out of 7 Laws) ① Ensure sufficient width for workers to work and move ② Install safety railings or fences in areas with a risk of falling ③ When overlapping and joining platforms, join them over joists, with an overlap length of at least 20cm ④ Provide at least 2 supports for each platform ⑤ The maximum width of the work platform must be within 1.6m ※ Note: No protruding nails, knots, or steel wires (Item 6) and prohibition of exceeding the maximum load capacity (Item 7) 3) Employer's Compliance Requirements for Installing Detours — 5 Items (Article 26 / Total 5 Items) ① Plan to maintain traffic flow ② Prohibit passage under bridges or high structures under construction (take necessary safety measures in unavoidable cases) ③ Install all traffic controls and traffic lights in compliance with traffic laws ④ Conduct thorough inspections to ensure constant maintenance, and install temporary lights if necessary ⑤ When the detour is completed Restore everything to its original state 📖 Basis: Article 9 (Steel Pipe Scaffolding), Article 15 (Passage Platforms), and Article 26 (Detour) of the Standard Safety Work Guidelines for Temporary Construction Works · Ministry of Employment and Labor Notice No. 2020-3 (Jan. 16, 2020) ━━━━━━━━━━━━━━━━━━━━━━ 🔮 Related Expected Questions • [High Probability of Appearance] Assembly Standards for Steel Pipe Scaffolding in Standard Safety Work Guidelines for Temporary Construction Works (Scaffolding column spacing, 1.5m tie beam, wall joint 5m×5m, etc.) • [High Probability of Appearance] Installation Standards for Temporary Passages (Ramps) (Slope 30 degrees or less, anti-slip devices, landings, etc.) • [Medium Probability of Appearance] Installation Standards for Ladder-type Passages / Compliance Requirements for Mobile Scaffolding • [Medium Probability of Appearance] Installation Standards for Fall Protection Nets and Protective Shelves (10m (Inner or less · Overhang length 2m or more · Angle 20~30 degrees) 📢 Jeong's Safety Classroom Past Exam Question Solution Series for Industrial Safety Instructor 2nd Round Exam Preparation Tags: Industrial Safety Instructor, Past Questions, Temporary Construction, Steel Pipe Frame Scaffolding, Passage Platform, Detour, Standard Safety Work Guidelines for Temporary Construction, Article 9, Article 15, Article 26, Scaffolding, Temporary Passage, 2nd Round Exam, 16th, Essay Type #IndustrialSafetyInstructor #PastQuestions #TemporaryConstruction #SteelPipeFrameScaffolding #PassagePlatform #Detour #StandardSafetyWorkGuidelinesForTemporaryConstruction #Article9 #Article15 #Article26 #2ndRoundExam #16thRound #EssayType