Ziroli F6F Hellcat Giant scale 2.5m with MVVS 80cc Flight by Pilot Tomislav

Petrinčič Brothers Tshirts here: https://shop.spreadshirt.com/petrini-... The giant scale F6F-3/5 Hellcat plan set is 1/5.3 scale and consists of four large sheets that clearly illustrate all structure as well as showing installation of flaps and retracts. The F6F-3/5 Hellcat plan shows the installation of Robart retracts, fixed wire gear, servos and Zenoah G-62 engine and features three piece wing. The basic structures use conventional “modeling” tools and materials such as balsa and plywood, and the techniques are straightforward; easily accomplished by anyone with previous model building experience. There are many online building threads at www.rcuniverse.com forums and www.rcscalebuilder.com forums for Nick’s plans. Tech support is also available via email at www.ziroliplans.com or by phone 9:00 to 5:00 Mon - Fri EST 631-467-4765. The plan includes full-size templates for all the required parts allowing you to cut a complete “kit” before you start construction. If you don’t have the tools or time to cut your own kit Nick Ziroli Plans now carries laser cut wood kits for the F6F-3/5 Hellcat plan. The plans have a separate instruction guide and building notes on the plans. If you choose gear or an engine not shown on the plans you should have them on hand when you start construction to make any changes needed for mounting. Nick Ziroli Plans recommends covering the airframe with 1 oz fiberglass cloth and ZAP Z-poxy finishing resin and elevator and rudder with iron on cloth covering such as Solartex..Nick Ziroli Plans has building and scale accessories available for the F6F-3/5 Hellcat. Plans Specifications: Specifications: F6F Hellcat Plan Scale: 1/5.3 Inches to the foot: 2.25" - 1' Length: 75" Weight: 32-42lbs Wing loading: 44-57oz/sqft Wing area: 1700 sq.in Wing span: 95" Wing incidence at root: +2 degrees Stab incidence: +1 degree Dihedral: 5" under W-15 Power: 62-85cc gas Washout at wing tip: 2 to 3 degrees built in with jig Aileron throws: 1" up and 3/4" down Elevator throws: 1" up and 1" down Rudder throws: 2" to right & 2" to left Flap degrees down: 40-50 Cowl length: 10.25" Cowl height front: 11.5" Cowl height rear: 14" Cowl width front:: 10" Cowl width rear: 12" Engine offset degrees: 2 right 3 down CG Location: 5 1/2" back from leading edge of the wing at the center section with gear up