Xterra Titan Swap Full Suspension Installation

Hello and welcome to another xtera video ! In this video I an finally working on upgrade my full suspension by doing a Titan Swap that I bought from Nisstec Lifts. It took me some time I had some issues but in the end it all got done ! hope you guys enjoy this video and might find it helpful ! Make sure you install upper control arm boll joins in correct orientation! one side had to be changed when I went for alignment Full kit bought from Nisstec Lifts ( Company closed down ) https://nissteclifts-com.3dcartstores... Alternative options http://xterraperformance.com/05-Xterr... https://www.z1offroad.com/lift-kits/t... https://www.alldogsoffroad.com/alldog... LEXIVON 1/2-Inch Drive Click Torque Wrench 25-250 Ft-Lb https://amzn.to/2WVp8PS Video Chapters 00:00 Intro 2:18 Preparation 3:40 Front Disassembling 19:34 Front Assembling 42:09 Rear Disassembling 46:06 Rear Assembling 54:54 The End Second Gen Nissan Xterra Torque Specs Front Suspension: LCA Bump Stop: 14 ft-lbs LCA Cam Bolt: 100 ft-lbs LCA Ball Joint Nut: 70 ft-lbs UCA Mount Bolt: 94 ft-lbs UCA Ball Joint Nut: 58 ft-lbs Lower Shock Mount: 155 ft-lbs Upper Shock Mount Nuts: 22 ft-lbs ( 3 nuts/bolts) Center Hub Nut: 101 ft-lbs (Replace Cotter Pin After Removal) Rear Suspension: Upper Shock Mount Nut: 33 ft-lbs Lower Shock Mount: 148 ft-lbs Spring Shackle: 77 ft-lbs (Both upper and lower) Front Leaf Spring Mount Bolt: 84 ft-lbs Axle U-Bolt Nuts: 53 ft-lbs All gear used to to make this video DJI OSMO Action = https://amzn.to/3v21Mnb SanDisk 128GB Extreme microSDXC = https://amzn.to/3v4dEF9 PGYTECH Camera Cage = https://amzn.to/3ehjRXJ Saramonic SR-XM1 3.5mm = https://amzn.to/3gmyvzm Dual USB-C 3.5mm Mic Adapter = https://amzn.to/2QERrOY Neewer 50-In-1 Action Camera Accessory Kit = https://amzn.to/3tI5ySg Neewer Battery Charger Set = https://amzn.to/3glcuRv Thank you very much for watching !