Custom Fiberglass Subwoofer enclosure

This is the complete process from start to finish on how to create a custom subwoofer enclosure for your car. This was done for a 2020 Camry XSE, but the process will be the same for any vehicle. Audio: Built For This Full by David Renda 00:00 - Intro 00:11 - Tape layer 00:55 - Chop mat 01:17 - Type of resin 01:54 - First layer of fiberglass 02:45 - Removing the form from the car 03:19 -Layers 2 to 6 of fiberglass 05:44 - Removing tape layer 06:13 - Subwoofer mount 09:14 - Trimming the enclosure 10:04 - gluing the sub-mount in place 10:41 - Enclosure front face 13:05 - Final sanding 13:21 - Final carpet layer 14:21 - Speaker wire installation 15:10 - quick disconnect 15:23 - Velcro installation 15:57 - Final product List of products used Some products were bought from stores locally, but I tried to compile a list of similar products. Feel free to substitute anything on this list with another product. Fiberglass Cloth Mat https://a.co/d/ajP1twd Fiberglass Resin + Hardener https://a.co/d/heNSF8J Black felt carpet https://www.amazon.ca/dp/B095PCFRDS?r... 2” paint brush https://www.homedepot.ca/product/hdg-... Mixing cups You don’t necessarily need these. I just used plastic drinking cups. Just make sure to test it before using to check if the resin will dissolve the plastic. I haven’t used the product below, but it is advertised specifically for mixing resin. https://a.co/d/0jYW7eO Quick disconnect – This is what I used, but I would not recommend. The wire isn’t 100% secure, and can be pulled out. https://www.homedepot.ca/product/idea... Would recommend a lever nut instead https://www.homedepot.ca/product/wago... Masking tape https://www.homedepot.ca/product/scot... Acetone https://www.homedepot.ca/product/solv... Plywood https://www.homedepot.ca/product/1000... Spray Adhesive https://www.homedepot.ca/product/gori... Trigger Clamp (C Clamp) https://www.homedepot.ca/product/gori... Hook and Loop fastener (AKA Velcro strip) https://www.homedepot.ca/product/velc... Miscellaneous • Stir stick • Grinder – To cut final shape and to smooth out stray fibers • Staple Gun – To secure felt • Hot glue gun – To secure felt • Jig saw – Cut out speaker mounts • Drill and Drill bits – drill hole for speaker wire • Utility Knife – to cut out a hole in the felt for the subwoofer • Marker • Cardboard or plastic liner to protect your work area and trunk from dripping resin • Face mask • Gloves • Safety glasses • Scissors