Citroen C5 EP6 Начал Дымить. Замена Маслосъемных Колпачков Не Помогла

Link to the list of purchased spare parts and instructions for replacing valve stem seals https://drive.google.com/drive/folder... Set of upgraded valve stem seals - Citroen/Peugeot 16 400 988 80 The footage was filmed in September and posted only in December. Basically, the car suddenly started smoking 2,000 km after an oil change. At first, I assumed the valve stem seals were faulty, but replacing them didn't help. Then I changed the oil, thinking it was a counterfeit and the oil wasn't working. Replacing it didn't help. Then I thought the bad oil was causing the oil rings to stick, and that was it. But the other day, my subscriber Vlad Armstrong wrote to me, and I'm so grateful for that! Vlad advised me to check the turbocharger, as it could be dumping oil into the hot part. So, I'll look into it; maybe it really is the turbocharger. Vlad, thank you so much! ____________________ 00:00 - Introduction 01:38 - Doggie 02:02 - Disassembling the Engine 03:26 - Inspecting the Camshafts 04:02 - Removing the Camshafts, Sprockets, and Squeegees 08:26 - Aligning the Piston Height to Release the Valve Springs 09:11 - Preparing to Release the Valve Springs 09:51 - Release and Release the Valve Springs 13:40 - It's Been a Bit Cold Out, Installing and Tightening the Camshafts 17:54 - Good Morning, Installing the Crankshaft Locking Tool, Sprockets, and Checking the Timing 24:34 - Installing the Valve Cover and Further Assembly 25:51 - Test Run of the Engine 26:27 - Repaired Turbocharger Inlet Pipe 27:24 - Repeated Test Run of the Engine 27:47 - Test Drive 28:38 - Still smoking 29:02 - Conclusions