How to install my Miele dishwasher FrontFit? | Miele

Watch this video for information and tips on how to install your Miele FrontFit dishwasher. This video does not replace the instructions for use and installation. Please refer to the chapter 'Safety instructions and warnings' in the instructions for use and installation. The following steps are required for installation: 1) Measure the overhang of the worktop to the front edge of the kitchen carcase. 2) Shorten the sides of the vapour protection foil according to the measured length. 3) Clean the underside of the worktop and attach the vapour protection film. 4) Attach the light guide. 5) Screw in the appliance feet. 6) Place the appliance in the niche. 7) Adjust the rear feet with the Torx screwdriver. Adjust the front feet with the slotted screwdriver. 8) Measure the distance between the mark on the dishwasher front and the top edge of the adjacent furniture front. 9) Mark the measured distance on the inside furniture front with a pencil. 10) Fit the runners. 11) Fasten the furniture front. 12) Using a Trox screwdriver, adjust the door so that it does not collide with the underlying kitchen carcase. 13) Insert the PowerDisk. 14) Adjust the door weight balance using the screw. 15) Connect the appliance and check that the connections are tight during the first rinse cycle. For more information about the appliance, please visit us here: https://www.miele.co.uk/e/dishwashers... Accessories and care products can be found here: https://www.miele.co.uk/e/dishwasher-... https://www.miele.co.uk/e/miele-dishw... If you have any problems, you can find help at: www.miele.com/service