HS107 Shopmade tailstock trepanning tool – Part 3
Since forever I’ve wanted to make a tailstock trepanning tool to use in my Harrison 140 lathe, inspired by David Wilks. In this series of videos I make a tool from a piece of scaffolding pipe, an MT3 stub adaptor and a few other bits. The vids were made over a span of many weeks, as sunshine was keeping me out of the shop. David Wilks:- / @userwl2850
▶︎
HS105 Shopmade tailstock trepanning tool – Part 2
▶︎
HS357 Tailstock alignment – Swan Valley Machine method
▶︎
Large Lathe Trepanning --- Zala Boss Design
▶︎
Lathe Trepanning - 99.9% Not Brain Surgery
▶︎
HS360 Harrison 140 lathe – spindle bearings removal
▶︎
Tailstock Quill . Part 3 . MT 2 Taper Boring & L/H Thread
▶︎
Making a Crazy Part on the Lathe
▶︎
HS43 Making a tailstock 4 jaw fitting for my Harrison 140 lathe
▶︎
Trepanning on the Lathe! Efficient and Tasty.
▶︎
Making a Face Grooving or Trepanning Tool for the Lathe - it failed!
▶︎
Intro to No Stress Threading: How to get started in single point threading
▶︎
Saying Goodbye to my machines. where are they now.
▶︎
Rusty pipe made into 9" Trepanning Tool. To cut 50" deep
▶︎
Grind a face trepanning tool for the lathe
▶︎
INCONEL 718 the most difficult alloy to machine
▶︎
How We Thread 30ft Drill Rods (Wild Megabore Setup!)
▶︎
Resetting my wonky tailstock.
▶︎
Homemade Tool Post Grinder - part 3 (spindle body)
▶︎
Power Trepanning on the Metal Lathe
▶︎