Ruger PC Carbine Recoil Reduction Bundle – Install Guide & Overview

THIS RUGER PC CARBINE RECOIL REDUCTION BUNDLE The extra power recoil spring featured in this video has been discontinued and is no longer available for purchase. This video is kept as a technical reference for disassembly, parts orientation, and general installation concepts for the shock buffer and stainless steel recoil spring retainer. In this video, we walk through the installation of a recoil reduction setup for the Ruger PC Carbine that includes a shock buffer, an extra power recoil spring, and a stainless steel recoil spring retainer. The goal of this combination is to help reduce felt recoil and bolt impact when installed correctly, while supporting reliable cycling and long-term durability of the internal components. We begin by confirming the firearm is clear, then cover the parts and tools needed. Next, we remove the barrel, separate the stock from the receiver, and pull the trigger assembly to expose the bolt and recoil system. We remove the factory buffer, spring, and clip, compare them to the upgraded components, and then install the new buffer, recoil spring, and stainless retainer. The video finishes with reassembly, a function check, and a brief wrap-up. Even though this specific bundle and extra power recoil spring are discontinued, the video remains a useful reference for understanding Ruger PC Carbine receiver disassembly, bolt and recoil assembly removal, and how to correctly install a shock buffer and stainless steel retainer in this platform. TIMECODES: Intro - 00:00 Parts Needed - 01:31 Tools Needed - 03:17 Firearm Clear - 03:31 Remove Barrel - 03:41 Other PC Carbine Upgrades - 03:53 Separating the Stock and Receiver - 04:52 Removing Trigger Assembly - 05:31 Receiver Overview - 06:29 Removing Bolt Assembly - 07:31 Removing Factory Buffer Spring and Clip - 08:31 Stock vs M*CARBO Parts Comparison - 09:13 Installing New Parts - 12:30 Reinstalling Bolt Assembly - 13:35 Reinstalling Trigger Group - 13:54 Reattaching Stock - 14:30 Reinstalling Charging Handle - 15:04 Reinsert Barrel - 15:20 Function Check - 15:34 Wrap-Up / Outro - 15:50 Safety & Responsibility: Always verify that your Ruger PC Carbine is completely unloaded before beginning any work. Remove the magazine, lock the bolt open, and visually and physically inspect the chamber to confirm it is clear. Keep the muzzle pointed in a safe direction and follow all standard firearm safety rules. Work in a safe, organized environment and use appropriate tools to avoid damaging the receiver, bolt, or recoil components. After any changes to the recoil system, perform thorough function checks and test the rifle at the range with appropriate ammunition to confirm safe and reliable cycling. Pay close attention to ejection pattern and bolt lockup. If you are unsure about any part of the disassembly, installation, or reassembly process, or do not feel fully confident performing it yourself, consult a qualified gunsmith. This content is for educational and informational purposes only and is intended for responsible, legally authorized firearm owners in accordance with all applicable local, state, and federal laws. #MCARBO #RugerPCCarbine #RugerPCC