Ford 8560 New Holland Range transmission calibration with hydraulic pressure test

Semi power shift transmission Transmission Calibration procedure for Tractor NEW HOLLAND TM Series and 60 series .TM 165 Range Command Calibration Mode Handbrake UP ! Press and hold both the upshift and downshift buttons whilst starting the tractor. On entering the calibration mode, the display will show the temperature of the transmission oil in degrees centigrade. To continue with the calibration – Set the engine RPM to 1200 +/– 50 Place the shuttle lever in FORWARD Press the upshift button to select clutch A. If the start up procedure was incorrect, or if the oil is at the incorrect temperature, a U code will be displayed. Press and hold the downshift button to calibrate clutch A. Keep the downshift button depressed until the engine speed decreases by 50 RPM and the calibration number alternates with the clutch identifying letter. Release the downshift button to progress to the next clutch. Follow the same procedure as clutch A to calibrate clutch B. Then continue in the same manner for clutches C,D,E and F calibration. Calibration “F”, moves the two range synchronisers into the neutral position. If all is OK, “CF” will appear. NOTE: The two range potentiometers are automatically calibrated during the calibration of the five clutches. At this point, the calibration has been completed, and the Key start can be switched off to store the new calibration figures.