Como instalar rastreador veicular com bloqueio

How to Install a Vehicle Tracker with a Lock If you want to learn how to install a vehicle tracker with a lock, you'll learn how. 🔴 Link to my 10k Tracking course: https://rastreamentonapratica.kpages.... To install a vehicle tracker with a lock, you need a multimeter, wire cutters, stripping pliers, electrical tape, some plastic straps, tin, and solder. You may also need a Phillips screwdriver, a flathead screwdriver, a Torx screwdriver, or a wrench and plastic spatulas to remove the car's dashboard when installing the lock. To install a tracker, it's essential to first remove any jewelry, such as rings and bracelets, to avoid accidents when hiding the tracker in the vehicle's dashboard. You'll need to have the tracker harness, the interlock relay, and the tracker ready before the customer arrives at your store to avoid delays in installation. 🔗 Where to buy the tracker in this video: https://www.lojadorastreador.com/ The tracker has a negative wire (which you connect to the vehicle's can), a positive wire that you connect to a 12V wire from the vehicle, and a post-key wire that you connect to a wire that is only positive with the key half-turned or the engine running. There's also the tracker interlock, which you connect with a five-pin relay, or the relay from the tracker store, which is already designed for trackers and comes with only the necessary wires. When you find the vehicle's interlock wire, cut it, connect pin 87A of the relay to one end, pin 30 of the relay to the other, and connect pin 85 to the end that has power with the cut wire. Connect pin 86 of the relay to the tracker's negative wire when you select "lock" in the tracker app. Note: Never begin your installation with the tracker plugged in; this may illuminate a malfunction light on the dashboard, depending on the vehicle. Also, do not plug the tracker into the power outlet after connecting the positive and negative terminals, with the internal battery activated. You may have made a mistake and will only know after the device's internal battery discharges. Avoid leaving the tracker hidden with the LEDs facing down; the GPS signal works best with the antenna facing up. If you learned how to install a vehicle tracker, leave a comment below.