Les Paul Broken Neck Repair EP3

Welcome to the Next Project! Continuing the repair of a broken headstock Les Paul. We are getting close to having this neck ready to glue to the body...accept for all that sanding, bah! 00:00 - lights, camera, action 00:03 - intro 00:20 - fingerboard prep & bind 02:08 - headstock binding prep 03:40 - headstock binding 06:02 - had enough, there's more 06:40 - wheel notch 07:37 - where are my glasses 10:08 - fingerboard glue-up 13:02 - just sanding in line 14:06 - where are we 15:51 - fresh radius 16:59 - deluxe tuner holes With the original headstock logo veneer applied to this new neck, I've been able to move things along. Routed a rabbet around the headstock, added binding as an upgrade - looks nice! Prepped the original fingerboard, plugged the old marker dot holes and added new binding. Cut in an access notch at the high end of the fingerboard for the truss rod wheel. A lot of sanding, scraping and prep work, a lot! Glued the old fingerboard to the new neck, and it's really starting to look promising now! More sanding and scraping, pretty much everywhere. Re-radiused the fingerboard, now it's a 14" radius... originally was a 12" (mostly). Don't worry, the original bridge will still work, more on that later. Tuning machine mounting holes were then drilled, but we made a thicker headstock - so, addressing the issue of the limited tuner reach needed to be resolved. I chose to create a recessed "well" for the washer and mounting nut to sit down in. Now the top mounting hardware will sit below the surface of the headstock = pretty custom! Thanks for joining me for this project, be sure to hurry back as there is a lot left to do. New videos will be rolling out as quickly as I can get all the repair and editing done. Hope you are doing well. Be safe and take care! #lespaul #epiphone #luthier