Your drone racing club NEEDS this FPV lap timer! // NUCLEARHAZARD

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: https://www.fpvknowitall.com/ultimate... SUPPORT ME ON PATREON at: http://bit.ly/2Ep5Sia THIS IS MY FULL TIME JOB. Here are other ways that you can support me: https://www.fpvknowitall.com/support-me/ --- The entire project is at: https://nuclearquads.github.io/ Buy complete pre-assembled lap timer: https://www.etsy.com/listing/16049794... Buy the "base" timing kit (mainboard and fan): https://nuclearquads.etsy.com/listing... Buy the receiver modules (one per channel you want to monitor, up to 8x): https://nuclearquads.etsy.com/listing... Buy the case (if you don't want to print your own): https://nuclearquads.etsy.com/listing... --- 00:00:00 - The easiest way to build an event-worthy FPV lap timer 00:02:28 - Where to buy this 00:03:49 - Mount the mainbaord in the case 00:05:16 - Insert the RX5808 receiver modules 00:07:11 - The Raspberry Pi 00:09:18 - Install the fan on the lid 00:11:36 - Install the Raspberry Pi OS on the SD card 00:15:10 - Boot up the Raspberry Pi 00:16:13 - Connect to the RotorHazard with SSH Download PuTTY at: https://putty.org/ 00:17:45 - Install the RotorHazard Install Manager https://github.com/RotorHazard/RH_Ins... 00:20:15 - Install and configure the RotorHazard server 00:23:05 - Configure auto-wifi-hotspot on the server 00:23:58 - Set up port forwarding for easy access Instructions are at: https://github.com/RotorHazard/RotorH... 00:24:38 - Set up server to auto-run on powerup Instructions for setup: https://github.com/RotorHazard/RotorH... 00:27:40 - Reboot the server and test it out! 00:28:12 - Rotorhazard deserves a whole video of its own! FPVSim Timer:    • Video   LiveTime walk-through:    • ImmersionRC LapRF Lap Timer and LiveTime W...