Kato Unitrack Turnout Operation using Toggle and Pushbutton Switches

NOTE: THE TWO LEDS CAN BE CONNECTED VIA A SINGLE RESISTOR RATHER THAN TWO SEPARATE RESISTORS This video covers a basic circuit used to operate a Kato Turnout using a Toggle Switch and a Momentary Pushbutton Switch. The circuit is explained in detail and then followed by a practical demonstration. There are various other ways of operating the Kato Turnout, this is the way I did it before I moved over to operating my turnouts using DCC. You will need: 1 x DPDT ON-ON Toggle Switch (1 per turnout) 1 x Momentary Pushbutton Switch (1 per turnout) 12V DC power supply (I would recommend getting a 2 Amp or greater power supply if you are purchasing a new one) Wire Solder If you want to add LEDs: 2 x Green LEDs (3mm or 5mm) 2 x 680 ohm or 1000 ohm resistors or 2 x Bipolar LEDs (3mm or 5mm) 2 x 680 ohm resistors Australian T Trak website https://sites.google.com/view/austral... T Trak, Ntrak website https://www.ntrak.org Kato Unitrack website https://www.unitrack-kato.com/