ADJUSTABLE FRICTION SAVER: How to Make One at LITTLE to NO COST to You for Arborists & Tree Climbers

In this episode, I’ll show you step by step how you can make your very own high quality, adjustable friction saver at a low to no cost to you! You’ll need a length of rope (you choose the length) that is rated for climbing, an approximately 45” long length of accessory or hitch cord, two anchor rings of different sizes and that’s it! Simply tie a loop around the smaller ring using a double fisherman’s bend and then use it to tie a French prusik on the rope! Next, secure the larger ring at the end of the rope by using a termination knot of your choice; I suggest either an anchor hitch or a poacher’s knot! Tape any loose tail to the standing end of the rope to ensure it doesn’t get caught on anything at height. But not right up against the knot. You need to be able to examine the knot to check for any slipping. Finally, tie a fixed loop knot, like a bowline with a Yosemite finish (as small as you can tie it) or have a sewn or spliced eye made. This allows an additional connection point for other applications, including but not limited to using it to connect to your throwline as means of taking the friction saver down. There you go! You’ve made a high quality friction saver that will not only perform, but it will last for years! If you made a friction saver, I’d love to see it! Post a picture in the comments (I think you can do that?)!