how to change a drivers seat switch on a 2007-2017 Ford expedition

link to replacement switch below https://amzn.to/4oFHSvo commissions earned Step-by-Step Replacement Guide1. Safety and PreparationPower down: Turn off the ignition and remove the key.Disconnect battery (Recommended): Disconnect the negative battery terminal to prevent accidental short circuits or airbag faults.Position the seat: If the seat still moves at all, raise it to its highest position to give yourself more room to work under the cushion.2. Remove the Seat Side Trim PanelLocate retaining screws: Look at the back and lower edges of the plastic trim panel on the side of the seat. You will usually find one or two screws holding it to the seat frame.Unscrew the panel: Remove these screws using your Phillips or Torx screwdriver.Release the clips: Gently insert a plastic trim tool between the plastic panel and the leather/cloth seat cushion. Pry outward carefully to pop the plastic retaining clips loose.Pull the panel away: Slide the panel slightly forward and outward to unhook it from the seat frame. Do not yank it off completely, as wires are still attached.3. Swap the Seat SwitchDisconnect the wiring harness: Locate the electrical plug connected to the back of the seat switch. Press the locking tab and pull the harness straight out.Unmount the old switch: The switch is held into the plastic trim panel by small plastic tabs or screws. Depress the tabs with a small flathead screwdriver (or remove the screws) and push the old switch out through the front of the panel.Install the new switch: Snap the new switch into the trim panel until it clicks firmly into place.Reconnect power: Plug th