My Snapmaker U1 is trolling me 😅🖨️
It’s supposed to automatically refill the filament… but instead it crashes into an MCU error 🙈 And that’s not even the weirdest part it gets even stranger after that 🤯 Has anyone else seen this issue before? Let me know down in the comments 👇 #3Dprinting #snapmaker #mcuerror #makerlife #fdmprinting #PaBloMakes
▶︎
I Finally Upgraded My Snapmaker U1
▶︎
I Switched From Bambu to Snapmaker U1- 6 Month Honest Review (2,700 Hours Tested)
▶︎
Hello Bambu Lab. I want to PLAY A GAME !
▶︎
Change these settings for the BEST Support!
▶︎
U1 vs H2C? Here's What I Found
▶︎
Best Settings for Anycubic Kobra X | Best Quaity, Multicolor Prints, and more!
▶︎
Snapmaker U1 | Multicolor 3D printer without waste - Prusa XL & AMS comparison
▶︎
The Surprising Flaws in 18650 Lithium-Ion Batteries
▶︎
Testing two community Snapmaker U1 top covers - Cheap enclosures
▶︎
Snapmaker U1 Mods & Upgrades You Must Try 🔥 | Enclosure, Heater, Dry Box & More
▶︎
This $1000 Toolchanger Isn’t Supposed to Have Problems… Right?
▶︎
Snapmaker U1 Tool Changer 3D Printer Review - A Master Class In Reading The Room!
▶︎
Flexing on TPU: The Best Flexible Filament Alternatives for 3D Printing
▶︎
Snapmaker U1 Upgrades: Better or Worse?
▶︎
I Was SICK of Drying Filament, so I Built THIS Instead.
▶︎
Filament Calibration Masterclass – 95% do it wrong!
▶︎
Snapmaker U1 - Unboxing, Setting Up and Working through Calibration
▶︎
I Thought This Toolchanger Would Be Janky
▶︎
Should You Buy the Snapmaker U1? Full Review
▶︎