Upgrade Your Motorcycle with This Game-Changing DC CDI!

In this video I'm gonna show you how to make a DC CDI box for your motorcycle. Custom DC CDI unit designed for optimized ignition performance in motorcycles. Tailored for both sport and street engines, this high-performance CDI enhances spark strength, providing faster starts and improved engine power. 📌One of the advantages of this CDI, DC CDI,is that it produces a stronger and more stable spark, leading to complete fuel combustion, This results in better fuel efficiency. Another benefit is that it can be installed on multi-cylinder motorcycles (with slight modifications). Additionally, this CDI is compatible with both DC and AC-powered motorcycles, and it can even be used on fuel-injected motorcycles. Intro: 00:00 All parts: 00:45 Diagram: 01:39 Building PCB Board: 01:45 Asambleing parts: 02:40 Building Set-up transformer : 05:38 Transformer diagram and winding details: 07:36 Important tip: 11:18 CDI Test : 11:40 Outro : 13:19 --------------------------------- #automobile #motorcycle #cdi #ignitioncoil #custom #modified #diy #ignitionsystem #experiment #dc #electronic #flyback #transformer 📌Transformer Specifications: Given the high frequency of oscillation (above 150 kHz), ferrite core transformers are utilized. A compact 13mm EE core transformer can effectively perform the task, although handling such a small component may be challenging. A slightly larger core can also be selected. For windings, use enameled copper wire: 0.33 - 0.38mm for the primary (L1) and 0.20 - 0.25mm for the secondary windings (L2 & L3). Primary Winding: Start winding from pin 6, make 22 neat turns in the direction shown, and finish at pin 4. Cover this winding with transformer tape. Secondary Winding: Start from pin 1, make 140 turns in the same direction as the primary winding. Tap at pin 2, continue for an additional 27 turns, and end at pin 3. Once finished, cover the winding with tape. Assembly: Assemble the two EEs, leaving a small air gap between them. To achieve this, a tiny piece of paper packing can be used. Finally, secure the two EEs together with tape. New video ultimate CDI upgrade:    • Boost Your Motorcycle’s Performance with T...   ⚠️An important point : 1,the transformer is the heart of the circuit. If the transformer is not wound correctly or if the winding direction is incorrect, oscillation will not occur, and the circuit will not function. 2,For better testing, the ignition coil should be connected in the circuit. ⚠️Important points about doubts: 1: The base of Q1, C3, the cathode of the Schottky diode D4, and the collector of Q2 are all connected together. 2: The upper terminal of the transformer is connected only to the resistor R3 (4.7k). _Regarding the transformer: 3: Since the winding is done counterclockwise, the end of L2 goes to the positive input, and the end of L3 goes to the 100-ohm resistor. Related videos: Ignition Systems tutorial:    • How to increase ignition power, simple and...   👉If you like it, Don't forget to like and share it with your friends Thanks Subscribe to the channel for more awesome projects 😁 good luck ♥️