ЧПУ-плазма своими руками: полный обзор готового станка

A detailed review of a plasma cutting machine built from steel tubing. At the time of filming, the machine had been in production for over two months. During this time, it was used to cut parts for our serial products. During this time, it completely paid for itself and earned enough money for a full upgrade. Despite all the design flaws, the machine also saved a huge amount of time and hassle by eliminating the need for third-party cutting contractors. =-=-= Machine in operation: First idle movements in manual mode:    • Тест холостых перемещений в ручном режиме   Reference point approach test:    • Тест выхода в референтную точку   G-code execution test:    • Тест исполнения G-кода   First part cut:    • Резка первой детали   Machine after upgrade: Idle movements:    • Станок плазменной резки v2.0   V2.0 machine in operation:    • Станок плазменной резки v2.0 в работе   V2.0 machine after installing the Hypertherm plasma source:    • Станок плазменной резки с источником Hyper...   Full construction videos here: Introduction:    • ЧПУ-плазма своими руками: введение   Part 1. Assembling the work table:    • ЧПУ-плазма своими руками: сборка стола   Part 2. Gantry carriages:    • ЧПУ-плазма своими руками: каретки портала   Part 3. Assembling the Z-axis:    • ЧПУ-плазма своими руками: ось Z   Part 4. Assembling the guides and gantry:    • ЧПУ-плазма своими руками: сборка направляю...   Part 5. Installing the gantry on the work table:    • ЧПУ-плазма своими руками: установка портал...   Part 6. Troubleshooting:    • ЧПУ-плазма своими руками: работа над ошибками   Part 7. Assembling the water pan:    • ЧПУ-плазма своими руками: сборка водяного ...   Part 8. Machine control unit (electronics):    • ЧПУ-плазма своими руками: блок управления ...