MacBook Air M1 A2337 Battery Replacement, How To Guide

Need parts for the 2020 MacBook Air 13" A2337 ? 👉👉https://tekdep.com/product-category/f... Ship us your laptop or iPad for repairs! 👉👉https://tekdep.com/repair/ Full Battery replacement guide of the 13" MacBook Air 2020 A2337. Subscribe for more! We appreciate you guys Visit Our Website To Find All Parts & Tools 👉👉 https://www.TEKDEP.com 00:00 - Introduction Overview of the repair: replacing the battery and charging port on a 2020 M1 MacBook Air (Model A2337). Parts and tools are linked in the description or available at tekdep.com. 00:34 - Disassembly Begins Removing the protective case and all ten pentalobe screws from the bottom case. Use a suction cup to lift the case. 01:06 - Disconnecting the Battery Always disconnect the battery first. Remove the retention clip on the battery connector using a spudger. 01:46 - Removing the Charging Port Using a T3 screwdriver, remove the two screws and bracket securing the charging port connector. Then switch to a T5 to remove the screws holding the port in place. 03:00 - Installing the New Charging Port Insert the new charging port, screw it in place with the T5 screws, and reconnect it using the retention bracket and T3 screws. 03:43 - Speaker Removal Setup Start the battery removal by removing the T3 screw securing the trackpad flex cable bracket and the screws securing the speakers. 04:27 - Speaker Adhesive Challenges Attempt to use pull tabs on speakers; if they snap, use isopropyl alcohol to weaken the adhesive. 05:04 - Speaker Disconnection and Removal Unplug the speaker cables and carefully pry out the speakers. One speaker cracks during removal but will be replaced. 06:19 - Battery Tray Screws and Pull Tabs Remove battery tray screws. Pull tabs for battery adhesive mostly cooperate except for one center tab. 07:41 - Removing the Old Battery Use the adhesive channels to pry off the battery where pull tabs failed. Disconnect the trackpad flex and remove the battery. 08:25 - Preparing the New Battery Insert and align the new battery. Secure it with T3 screws. 09:00 - Reinstalling Speakers Reconnect and screw in the speakers. Replace the damaged one later. 09:45 - Reinstalling Trackpad Flex Cable Reconnect the trackpad cable and secure the bracket over it with T3 screws. 10:43 - Final Reassembly and Testing Reconnect the battery, plug in the charger, and confirm the unit powers on and charges properly. 11:27 - Wrapping Up Confirm charging functionality. Reinstall the bottom case with the correct screw placement. 12:09 - Outro and Service Info Mention of available parts, tools, and mail-in repair or data recovery services at tekdep.com. Thanking viewers and encouraging likes, comments, and subscriptions. Instagram:   / tekdep   Facebook:   / tekdep.store   Twitter:   / tekdepc   Important Safety & Liability Disclaimer, TEKDEP™ / tekdep.com and the ownership assumes no liability for property damage or injury incurred as a result of any of the information contained in this website and all videos, blogs & pictures. TEKDEP™ recommends safe practices when working with electronics, batteries, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of TekDep, no information contained in this website shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of the tools, equipment, or the information contained in this website or Tekdep videos, blogs & social media is the sole responsibility of the user and not Tekdep. Only attempt your own repairs if you can accept personal responsibility for the results, whether they are good or bad and do your research before attempting any disassembly or repair, make sure you understand the risk you're taking.