[HOWTO] TURN A LAN PORT INTO A WAN PORT!! [Linksys E900 Wireless Router]

SUPPORT ME ON PATREON:   / behfor   Commands used in this video: nvram show | grep vlan.*ports [To show the current VLANs + Ports] nvram set vlan1ports="0 1 2 5*" [To remove port 3 (external port 4) from VLAN 1] nvram set vlan2ports="3 4 5" [To add port 3 (external port 4) to VLAN2] nvram commit [To save the configuration]** reboot [To reboot the router] ** If the new VLAN settings did not save after the reboot (in Tomato firmware) then I would also add this line before the nvram commit: nvram set manual_boot_nv=1 nvram commit reboot -Only Broadcom based devices support port-based VLAN's -The CPU Internal port number might be 8 for some wireless routers DD-WRT Wiki [switched ports] - https://www.dd-wrt.com/wiki/index.php... DD-WRT Wiki [Vlan support] - https://www.dd-wrt.com/wiki/index.php... Related Videos: How to instal Tomato:    • [HOWTO] Install Tomato Firmware on a Links...   How to install DD-WRT:    • [HOWTO] Install DD-WRT on my Wireless Rout...   Turning a wireless router into a switch and access point:    • [HOWTO] Turn an Old Wireless Router into a...   Disclaimer: Please install and use any third party firmware on your wireless router at your own risk and beware doing this might void the manufacturer's warranty and if something goes wrong there is a chance to permanently damage and brick your wireless router. I do not hold any responsibility on what happens after you use the information in this video. This video is for educational purposes only. #LAN #WAN #Router #DDWRT #Tomato