AN EASY WAY TO MAKE NAMED / CUSTOMISED PET TAGS WITH RESIN.

#ResinPetTag#CustomPetTag#ResinDogTags Welcome to my channel. In this video I will show you how I made these cute little custom pet tags. Adding the text is easy, you just need a printer, a cellophane bag and some clear sticky sellotape to seal the ink in. I filled the molds up as much as I could to dome them. Normally resin shrinks as it cures and the back edge would be a little sharp. By overfilling, it gave a much smoother end result which just needed a little filing down. I think its important that the tags don't scratch the pets so that is how I do it. The downside is that it covers the hole with resin and it has to be drilled out again. I used a small size bone tag mold. It's only about 1.6 inches wide. The pets are quite small so they were a good size but of course they do make bigger ones for bigger pets too. Watch along as I go step by step and show you how I did it. I do hope you like the dogs wearing them footage. It was not easy getting the furry friends to stay so still. I think they did well though and they seemed to like their new tags. Products I used Small Size Silicone Bone Pet Tag resin Casting Mold- From Ebay Epideco Pro Cast Max Epoxy Resin- Bought online at epideco.co.uk Hemway Craft Glitter In Mother Of Pearl - From Hemway.com or on Ebay Blue Glitter - From a kit bought in Hobbycraft Cellophane Bags 100 Micron Thick - From the craft section at Poundland Pet Tag Rings - From Ebay You will also need a printer and cellotape to seal the print in. An alternative way to print the text is to use A4 sheets of printable clear acetate which are suitable an inkjet printer. They do them on Ebay. You can also catch me on instagram at- roselily-resin-creations. My facebook page is @Roselilyresincreations. Safety note. Please always wear gloves and a mask when working with liquid resin.