Dynaco Mark III Rebuild & Testing Inrush Current Limiter (Part 2)
In this video I review the rebuild I performed on the first Dynaco MK3 that we repaired in the prior video. We also experiment with adding a CL-80 inrush current limiter using my HP 6813a AC Power Source/Analyzer, why not?
▶︎
Dynaco Mark III "Restoration" Gone Wrong – Let's fix it (Part 1)
▶︎
EEVblog 1752 - Texas Instruments SCREWED UP the NE5532!
▶︎
Is the Dynaco mark III monoblock worth the consideration?
▶︎
DO NOT BUY 1% Resistors from Amazon. I REGRET IT.
▶︎
The Ten-Engine Titan: Inside the B-36 Peacemaker, The Cold War’s Largest Bomber
▶︎
Reviving a Vintage Tektronix 575 Curve Tracer: Power-On, Diagnostics, and Fixes
▶︎
Getting my HALO back! - Parasound's A52
▶︎
Your Memory Cards Are Probably Fake
▶︎
How An Isolated Dim Bulb Tester Works (Current Limited Isolation Transformer And VARIAC)
▶︎
Tested: Where Does The Tone Come From In A Microphone Preamp?
▶︎
Fixing a trash-picked CRT Television
▶︎
Dynaco Mark III - MK 3 - Restoration Part 1 - BG066
▶︎
Stanford Research Systems SR510 Lock-in Amplifier
▶︎
My Off-Grid Battery Bank Failed... Here's What Happened
▶︎
Dynaco ST-70 Original vs. VTA Bench & Listening Test Comparisons - Stereo 70 Tube Amp
▶︎
Fluke 5205A Precision Amplifier Repair - Coffee Spill - More difficult than it had to be!
▶︎
MOSFET vs Transistor vs Relay: Most People Get This Wrong
▶︎
Dynaco Mark III - MK 3 - Restoration Part 8 - BG080
▶︎
Inside Dyson’s Overengineered £1000 Hand Dryer
▶︎