[Quick Demo] Sleeve Embroidery Using the 4.25" x 13" Mighty Hoop

Adding text to a hoodie using machine embroidery. Thanks for watching my video. Hopefully, this was either helpful or entertaining to somebody out there! 🔔 Subscribe for more decorating videos like this ➡️ https://bit.ly/3lPkpbk 🧵 Embroidery Supplies: Embroidery Thread Starter Set - https://amzn.to/3PJGLsa Cut Away Stabilizer Backing - https://amzn.to/3OPYTPR Magna-Glide “L” Bobbins - https://amzn.to/3DLzepi GROZ-BECKERT Titanium Needles - https://amzn.to/3vxRWw4 Jerzees Hoodie - https://amzn.to/3gm9wi6 Mighty Hoops – https://mightyhoop.com Melco Equipment - https://shopmelco.com/ 📷 Camera Equipment I use: Sony ZV-1 Digital Camera - https://amzn.to/3ShlnfJ K&N Tripod - https://amzn.to/3V0wxG4 Neewer Lighting - https://amzn.to/3UQqfJK Rode Wireless Go II - https://amzn.to/3PQ4aIq 🕛 🕛 VIDEO CHAPTERS 🕛 🕛 00:00 – Intro/Setup 02:13 – Embroidery 02:55 – Cleanup 📝 Detailed Breakdown: For this project, we will be demonstrating how to add some text onto a hoodie sleeve by using the 4.25" x 13" vertical/sleeve Mighty Hoop. The materials we will be using is the hoop, one sheet of 3.0 oz cut away stabilizer which will be folded in half for extra support and the hoodie itself. In order to set this all up, we first lay down the bottom hoop and place the stabilizer on top. To hold this into place, we use some tape at the top and bottom of the stabilizer as we do not currently have the stabilizer holder for this hoop. With this, we carefully slide the bottom hoop and stabilizer into the sleeve and use the fabric fold line to line the hoop up with the center of the sleeve. Once we are sure everything is in place where we want it, we snap the top hoop on and are ready to take it over to the embroidery machine. When putting the hoop onto the embroidery machine, we want to take extra caution to make sure nothing is going to get caught up during embroidery. To do this, we slide the bobbin arm through the head hole down the entire sleeve. and tuck all excess fabric underneath the machine making sure it is out of the way. When it is done, we remove the hoodie and hoop the clean up the final product. Simply remove the hoop from the hoodie and pull the sleeve inside out to trim up any excess stabilizer. Cut as close as possible to the text without cutting the hoodie. After that, the hoodie is done and ready to be worn! FULL DISCLAIMER: I make a small commission on my amazon affiliate links