Introduction to LTSPICE - OP-AMP Frequency Response and Slew Rate (Intermediate)
In this video I will show you how to build non-inverting amplifier using ADI OP27. Then we show the frequency limitations and slew rate applied to AC analysis and sine wave. We have also shown that the unity gain amplifier is stable with under damped response that leads to 20% overshoot.
▶︎
Introduction to LTSPICE: Frequency Response, Step Response and Sinusoidal Response for RC Circuit.
▶︎
Stanford Research Systems SR510 Lock-in Amplifier
▶︎
The 1.25V Trick That Gives You Any Voltage You Want
▶︎
LT Spice with Mike Engelhardt, 1/6
▶︎
LTspice IV:Stability of Opamp Circuits
▶︎
How to model a spark gap in LTSpice
▶︎
Understanding VSWR and Return Loss
▶︎
Introduction to LTSPICE: Getting Started
▶︎
Something is jamming GPS over Europe. Here's what we found
▶︎
Integrated SSDs Should Be Illegal, But Why Would They Care!
▶︎
#136: What is a dB, dBm, dBu, dBc, etc. on a Spectrum Analyzer?
▶︎
EEVblog #600 - OpAmps Tutorial - What is an Operational Amplifier?
▶︎
Why Impedance Matching Still Matters for Transistors
▶︎
The Brilliant Mind Behind the Rolls-Royce Merlin Engine: Stanley Hooker, Engineering of an Empire
▶︎
MOSFET vs Transistor vs Relay: Most People Get This Wrong
▶︎
ECE3400 Lecture 27: BJT Push-Pull Amplifiers and VBE Multipliers (Analog Electronics, Georgia Tech)
▶︎
Intro to Op-Amps (Operational Amplifiers) | Basic Circuits
▶︎
PLC Troubleshooting 101. Basic Steps to Diagnose and Fix Your Machine
▶︎
EEVblog #516 - LTSPICE Tutorial - DC Operating Point Analysis
▶︎