Custom 3D Printer Enclosure Build! ~ DIY Woodworking

Don't hide away your 3D printer - make it part of the interior decor! In this video I run you through my 3D printer enclosure build that is fit for any room in your house. Using a minimalist, modern design with LED lighting and Oak accents. 👇 Links to tools/materials below👇 TOOLS/EQUIPMENT If you are interested in the tools and equipment I use in this video you can find all the information you need here: 👉 https://kit.co/mikeparsonscc 👈 Enjoy this build? Let me know in the comments below and subscribe if you want to see more! SOCIAL MEDIA/BEHIND THE SCENES If you want to see more of what I do check out my content here: https://linktr.ee/mikeparsonscc BUILD PROCESS The main cabinet is made using 18mm MDF glued and screwed together. This gets a primer coat and then painted gloss white as a finish. The rear panel is removable and slides into dados cut into the cabinet sides. It is made from 12mm MDF and finished in the same way. The cabinet has sections underneath the main area for the printer power supply and a drawer, as well as cutouts between the sections to allow for routing cables. The door is made with a solid Oak frame, joined using mitres, and a sheet of 4mm perspex glued in place with CA glue. The enclosure also has a MDF and Plywood drawer with a solid oak front panel and satin chrome handle. It is fitting using 450mm soft-close drawer runners and sits flush with the cabinet front when closed. All the solid wood is finished with OSMO Polyx Satin finish. I fitted a set of LED strip lights inside the main compartment and routed the cables out of the back along with the main power supply leads. The whole build took about 2 months overall (not full-time!) and was made using materials I mostly had on hand, apart from the perspex and drawer hardware so ended up being quite cheap all in all. #3dprinter #3dprinting #woodworking