AC 220V Multimode Learning Wireless Remote Control Switch 1-channel Relay Receiver Module

Aliexpress listing: https://www.aliexpress.com/store/prod... Link from DE: https://www.amazon.de/dp/B08CRGLWH2 AC 85V - 250V low cost single channel wireless remote control system with latching, toggle and momentary modes and remote fob code learning facility. How to use : About Working mode: 1) Momentary (Jog/Non-Latched) : Press one button is Working /ON. Loosen your finger on the same button is Stop/OFF. One channel switch need one buttons remote control. 2) Toggle (Self -lock/Self-Latched) : Press one button for one time is working/ON. Press the same button again is stop/OFF. 1 channel switch need one buttons remote control. 3) Latching (Inter-lock /Latched) : Press one button is working/ON, press another button is stop/OFF. 1 channel switch need 2 buttons remote control. Clearing the code : Push the learning button on the receivers for 8 times , the codes will be cleaned . After clearing the code, all the remote control cannot work any more. Learning the code : Momentary (Jog/Non-Latched) Push the learning key on the receiver once time , it comes into momentary setting mode . Wait for a moment , the LED will be off , it comes into learning state . Push the remote button , LED indicator on the receiver board will flash then come off . After 3 seconds, the LED indicator will be on again , learning successfully . Learning the code : Toggle (Self -lock/Self-Latched) Push the learning key on the receiver twice time , it comes into toggle setting mode Wait for a moment , the LED will be off , it comes into learning state . Push the remote button,LED indicator on the receiver board will flash then come off. After 3 seconds , the LED indicator will be on again , learning successfully . Learning the code : Latching (Inter-lock /Latched) Note: When you choose for latching mode , in order to learn more remote control , you need to learn two different button , the first time learnt is for “ON”, the second time learnt for “OFF”. 1 channel switch need 2 buttons remote control. For example : button A = ON , button B = OFF Push the learning key on the receiver triple time , it comes into latching mode . Wait for a moment , the LED indicator on the receiver board will flash then come off. Push the remote button A . LED flash for 5 times . Push the remote button B . Led flash for 5 times . After 3 seconds , the LED indicator will be on again , learning successfully. A = ON , B = OFF .