Honda Civic Distributor Oil Seal & O Ring Replacement

Honda Civic distributor disassemble and oil seal replacement. Engine B16A2, OBD1 Oil seal dimensions 12.5 x 22.5 x 5 in mm. OEM Honda part number: 30111-590-050 (NOK BH3888E) All Honda distributors made in 1990-2000 years are in pretty same construction, so this video is helpful for all Honda's made in this period( Accord, Civic, CRX, CR-V, Integra, HR-V, Shuttle, Prelude ant etc) who have a distributor in ignition system. keywords: Honda Civic distributor removal, remove, change, oil leak, oil seal change, new oil seal, bad O-ring, o ring, fix, repair, how to, DIY, EG, EK, 91-95, 96-00, 5gen, 6gen, rotor, dizzy cap, ignition module, ignition coil, crank position sensor, top dead center sensor Due to factors beyond the control of WellDoneTips, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. WellDoneTips assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. WellDoneTips recommends safe practices when working with the tools or equipment seen or implied in this video. Due to factors beyond the control of WellDoneTips, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not WellDoneTips.