Darkseid Custom Mcfarlane Figure

#photography #mcfarlane #actionfigures Darkseid custom Mcfarlane figure was the by far the easiest to mod. Just drill out the eyes with a small hand drill. Its soft plastic, so no effort is needed. Now attach the LED inside, hold down with UV Resin..... its tricky,, but is the hardest part..... it should take you 30 min..... Once attached hold down the slack inside using UV Resin, and cover the LED with black paper or apoxie sculpt to cap any light leaks. Now mix tranlucent dye for UV Resin,, yellow and red to get an orange . Apply with a fine tip applicator to the eye in thin layers and cure with the UV light. Drill through the neck into the torso with the Dremel. Cut a small notch in the back of the neck for the wires to sit. Thread the LED leads into the torso and connect to your desired effects board. Attach your power source and put the figure back together. If an internal battery is need you will need to solder a battery compartment inside and cut the exterior. I only use USB , so no batteries to remove or leak in the unit. Materials 1 flicker board 2 LEDs yellow 1 USB connection UV resin kit Sharing techniques to customize current action figures by painting or sculpting what is needed. Producing a figure the is either improved or just creating one from parts of other figures. BRIKSMAX Flashing Module Boards for DIY Lego/Moc Lighting https://www.amazon.com/dp/B08ZJ1DLB1/... INSTAGRAM photobella_photography FACEBOOK   / photobella.visual   Not sponsord by any company, all items are purchused by me and and items are created by me. Any links shared are only to share information to other creators.