SVT Focus Front Suspension Repair - Wheel Bearings, Ball Joints, Clutch Bleed and First Test Drive!

In this video, I repair many of the worn out pieces of the drivetrain and suspension on my 2004 SVT Focus EAP. This car is somewhat high miles so it needed lots of things fixed. I replaced both wheel bearings by pressing them out of the steering knuckles, I replace one of the drive axles with a new, aftermarket unit, I change transmission axle seals, ball joints, tie rod ends, reassemble the brakes, bleed the clutch and fill the transmission with the special fluid it requires. I hope you have enjoyed the progress made on this car. Many more videos to come on this project even still. I look forward to your comments! To purchase SVT Focus Wheel Bearings: https://amzn.to/3UqylIH To purchase SVT Focus Outer Tie Rod Ends: Motorcraft Left Front Outer: https://amzn.to/3G1kTX8 Motorcraft Right Front Outer: https://amzn.to/3EgdqlU To purchase SVT Focus 6-Speed Transmission Fluid: https://amzn.to/3fV6Zvd As an Amazon Associate, I earn from qualifying purchases. #SVTFocus #SuspensionRepair #First Drive 0:00 Bad Wheel Bearings 1:32 Front End Disassembly 2:45 Transmission Seal Replacement and Axle Install 4:25 Replacing Wheel Bearings in the Steering Knuckle 6:50 Replacing the Lower Ball Joint and Tie Rod End 8:32 Installing the Steering Knuckle and ABS Sensor 11:54 Installing the Brakes 13:40 Bleeding the Clutch and Filling the Transmission 15:12 First Drive