AEM FIC 6 Install Part 2 Extending and Routing - #Eclipse2GBuild

This was a bit more time consuming than the first part and I found a few mistakes from the first labeling and deleting the wires. Also the routing of the cable was way better than I expected. Super clean. below there are the Part1 -    • AEM FIC 6 Install Part 1 Wiring - Eclipse ...   Part3 -    • AEM FIC 6 Install Part 3 Soldering The Fin...   This is what I used: https://amzn.to/2IbWpLs - Solder seal wire - water proof https://amzn.to/2JQFUrp - Blow torch small https://amzn.to/2EPjym9 - Butane gas for blow torch https://amzn.to/2WKE5CA - 18 AWG 5 colors wire 25ft 6 rolls https://amzn.to/2QMX9e1 - Wire stripper / cutter https://amzn.to/2TsYqvk - Split Wire Loom 1/2 https://amzn.to/2TzvIsM - Split Wire Loom 3/8 Get some cool Car Mods Merch and help support the channel https://www.carmodsgarage.com/shop Contact: [email protected] Instagram: @carmodsgarage Twitter: @garage_mods Building cars for fun.