Discrete audio amplifer project PT20.1 distortion measurement
The project amp distortion is finally measured! Due to the limitations of my equipment, the measurements taken at 20Hz and 20KHz read excessively high. The amplifier will have to be measured when the boards are made with better equipment. However, I'm confident with the amplifier's performance. Patreon https://www.patreon.com/user?u=12254451 Mail: PO box 362, Vandalia, OH 45377 Email: [email protected] Thank You!
▶︎
Discrete audio amplifier project PT14.1 oscillation fixed and first power test
▶︎
Discrete audio amplifier project PT20 Measuring distortion with computer
▶︎
JAT EZ AMP audio amplifier project low cost and easy to build PART1
▶︎
Building circuits the hard way. An introduction to freeform electronics
▶︎
EEVblog #1178 - Build a $10 DIY EMC Probe
▶︎
LM1875, TDA2050 & JAT501 amplifier distortion measurement at 8 ohms
▶︎
Directivity of the ferrite antenna
▶︎
Let’s Build a Low Voltage Vacuum Tube Audio Amplifier
▶︎
The Fascinating Story of Tektronix, The Oregon Engineers Who Reinvented The Oscilloscope
▶︎
The Ultimate Op-Amp Comparison - Bandwidth, Slew Rate, Frequency Response, CMRR & More!
▶︎
Why class AB or B amplifiers dissipate more heat at lower power
▶︎
K7000 Velleman Signal Tracer Active Probe
▶︎
Why get a tube amp in 2026?
▶︎
JAT501 audio amplifier power tests on transformer supply
▶︎
Discrete audio amplifier project PT11.1 output bias and thermal stability
▶︎
Correcting hum, buzz or distortion in audio amplifier projects
▶︎
Build This Simple 8 Ohm Audio Dummy Load for Amplifier Testing
▶︎
The unbiased audio amplifier output stage
▶︎
The most useful tool ever for electronics repairs - (PWJ212)
▶︎