Контроль уровня воды в накопительном баке системы водоснабжения дома на дачном участке

#waterathome #watersupply #waterpipeline #DIY #dacha This article describes a modification to a two-stage water supply system in a country house with a garden plot: first, water from a well fills a storage tank in the basement, and then a pumping station pumps water from this tank, creating pressure in the house's water supply network. The modification involves installing an RKU-1M level control relay with an OVEN DS.P-3 sensor, which automatically turns on the well pump when the water in the tank runs low and turns it off when the tank is full. The article describes the features and selection of relays and sensors, as well as the installation and commissioning of the system. My DIY videos:    • Контроль уровня воды в накопительном баке ...      • Указатель уровня воды для бака своими руками      • Светодиодная подсветка рабочей зоны кухни:...      • Лайфхак для вертикального беспроводного пы...   00:00 Existing water supply system 04:36 What has already been done in the first stage of modification 07:30 What is not satisfactory about the existing system 08:08 Why all connections are made using union nut fittings 09:15 Turning on a well pump from the basement 09:55 How to turn on a well pump for outdoor irrigation 12:16 Existing well pump control circuit 12:55 How the RKU-1M level control relay works 15:25 Rationale for choosing the OWEN DS.P-3 sensor 18:19 How a detachable connection is made Sensor 20:54 Mounting the sensor on the tank 24:25 Electrical installation of the system on a DIN rail in the distribution board 28:05 Beginning system testing: water is being drawn from the tank 30:14 The relay has tripped on the lower level sensor, and the tank is filling from the well 31:31 The relay has tripped on the upper level sensor, and the well pump is shutting off 31:53 Testing completed successfully