3D Printed RC Boat Build! Biggest Project So Far!

3D Printed RC Race Boat! This is a fun project. I did a test run and it was fast and fun. Unfortunately it was windy and choppy so I did not get a good video. I will release a test run video after the winter! 0:00 0:15 Finding the STL 0:36 3D Printed Parts 0:53 Sanding and Gluing the Parts 2:49 Prepping Surface for Paint 3:27 Glazing Putty 3:59 Epoxy Coating 5:29 After Epoxy Coating Has Cured 5:44 Filling Imperfections Before Paint 6:49 Hardware 7:04 Measuring for Motor Mount 7:33 Drill Hole for Drive Shaft 7:51 Install Rudder Assembly 8:23 Epoxy Drive Shaft in Place 8:31 Prep Surface for Motor Mount 8:42 Epoxy Motor Mount in Place 8:59 Install Servo 9:08 Finished Boat Ready for Test Run 9:26 First Test Run Coming Soon! STL can be found here: https://www.thingiverse.com/thing:245... Designed by thepael Parts I used - Brushless Motor & ESC: https://www.amazon.com/dp/B095GNR1N2?... Flex Collet: https://www.amazon.com/dp/B09K3HGTZ5?... Propeller: https://www.amazon.com/dp/B07JQL6LYY?... Lipo Batteries: https://www.amazon.com/dp/B07Y56XHMK?... Rudder & Drive Shaft: https://www.ebay.com/itm/173865062345 Motor Mount:https://www.ebay.com/itm/222902551317...