How to configure an IPSec VPN on Juniper

#ipsec #vpn #junipernetworks Want to know how to allow two remote sites to securely pass traffic between each other? In this video I share how to configure a Route-Based IPSec VPN on two Juniper SRX firewalls. The type of VPN shared in this video is known as a Route-based VPN - this is due to the static route configured later in this video which directs the firewall to use the next hop of the st0 tunnel interface for local clients to reach the remote sites. Timestamps: 0:00 Intro 0:11 IPsec VPN overview 0:38 Configure WAN/LAN interfaces 0:48 Configure security zones 2:04 Configure IKE Phase 1 (Proposal) 3:21 Configure IKE Phase 1 (Policy) 4:04 Configure IKE Phase 1 (Gateway) 4:53 Configure IKE Phase 2 (Proposal) 5:55 Configure IKE Phase 2 (Policy) 6:25 Configure IKE Phase 2 (VPN) 7:46 Configure tunnel interface 8:07 Configure VPN route 8:36 Configure VPN zone 8:54 Configure VPN policy 11:06 Configure SRX-B 11:22 Verification For further details and step-by-step guidance on configuring IPSec VPNs on Junos, I recommend referring to Juniper's official documentation. You can find more information at the link below: https://www.juniper.net/documentation... ↤↤ ✿ ↦↦↦↦↦↤↤↤↤↤ ✿ ↦↦↦↦↦↤↤↤↤↤ ✿ ↦↦↦↦↦↤↤↤↤↤ ✿ ↦↦ 👍 Like the video (it helps a ton!) 💬 Comment below to share your opinion! 🔗 Share the video with anyone you think it might help :-) ↤↤ ✿ ↦↦↦↦↦↤↤↤↤↤ ✿ ↦↦↦↦↦↤↤↤↤↤ ✿ ↦↦↦↦↦↤↤↤↤↤ ✿ ↦↦ Thanks for watching the video. Subscribe to the channel to get more and press the BELL 🔔 icon to get notified when the next video drops.