BUILD GUIDE: Jupiter Rival Blaster (2021 Updated)

After the Proton Pack launched, we saw an uptick in purchases of Jupiter: our full-auto 3D-Printed rival blaster; so this is a long-needed update to the Jupiter build guide. To work with the Proton Pack, this build is for a 3s LiPo, but the same instructions still apply for 2s (just with different motors installed). This was edited slightly differently than our previous tutorials in order to condense the video down to only what's necessary to show at the time. If you like the new style or have any suggestions to improve upon our "crystal clear" tutorials, let us know in the comments below! To purchase the Out of Darts Jupiter or any of its compatible parts and Accessories, click here: https://outofdarts.com/collections/ju... To purchase the Proton Pack - the perfect upgrade to virtually any rival blaster, click here: https://outofdarts.com/collections/pr... FAQ & Corrections: -If you have any questions about products we sell on the shop, don't hesitate to shoot us an email: [email protected] The rev trigger is a lever switch and the firing trigger switch is a button switch. During production, we accidentally grabbed a lever switch from the wrong bin. The kit should always include the correct switches. Thanks to an astute viewer for letting us know to clarify! Partial Body Assembly: You may find it easier to fasten the body together by screwing from inside the battery compartment 0:00 Opening & Introduction 0:37 LiPo Safety Brief 1:04 Printed Documents Available (Including Wiring Diagram) 1:21 What's Included in the Kit 2:47 Tools Required 3:18 Partial Body Assembly 3:42 Installing the Switches & Triggers 5:30 Installing the Battery Door Screw 6:05 Installing the Flywheels 7:27 Wiring the N20 Gear Motor (Positive Side) 10:27 Wiring the Switches and Flywheels (Positive Side) 14:41 Wiring the Switches and Flywheels (Negative Side) 18:52 Installing the Triggers 19:43 Wiring the N20 Gear Motor (Negative Side) 21:02 Wiring the XT-60 Connector 22:47 Finishing the Body Assembly 24:48 Test Firing & Installing the Battery Door 26:02 Closing Remarks Out of Darts, run by Luke, is a one-stop nerf-modding hobby shop. We carry all the supplies, tool accessories to make your modding journey easier! We create original 3D-printed blasters and mod parts with almost 100 Prusa printers. Check out our site below for guides, build lists, and resources. Please subscribe for more! http://tinyurl.com/jnuot5d My web store: https://www.outofdarts.com Product questions? [email protected] Follow me on Instagram for sneak peeks:   / outofdarts   Edited by J Perry Heun, Out of Darts Video Editor