Homemade cartridge brass annealer

My Water Cooled Induction annealer. Again, I want to make it 100% clear that I am not an electronic engineer, so take anything in this video with a grain of salt. Handloading can be dangerous and annealing is one of the last steps you need to do to maintain accuracy in your loading. It is not necessary, but it will (if done properly) lengthen the life of your brass and lengthen the window of consistency that you will have. Proper annealing will help maintain consistent neck tension and shoulder bump as you size cases. Sniper’s Hide thread: https://www.snipershide.com/shooting/... Annealing Article: https://vacaero.com/information-resou... Amazon parts list: As of September 2020, the cost of the parts is around $170. I did not include wiring (use something like 12 AWG stranded) and the pigtail (for an appliance like a dishwasher, use a 3 wire pigtail) for the power supply, as I already had those on hand, but you can include those as well. Power Supply: https://www.amazon.com/gp/product/B01... ZVS Induction Board: https://www.amazon.com/gp/product/B07... Timer Relay: https://www.amazon.com/gp/product/B07... Button: https://www.amazon.com/gp/product/B06... Water coolant reservoir and pump: https://www.amazon.com/gp/product/B01... Buck converter: https://www.amazon.com/gp/product/B07... Water cooler radiator with fan: https://www.amazon.com/gp/product/B07... Copper tubing: https://www.amazon.com/gp/product/B07... Clear tubing: https://www.amazon.com/gp/product/B00... Brass compression fitting: https://www.amazon.com/gp/product/B00... Brass fitting: https://www.amazon.com/gp/product/B00... Water Wetter: https://www.amazon.com/gp/product/B00... I'll monitor the comment section on here to respond to questions. I will do another video when I rewire it, so that everyone can see where everything goes.