GANTI KABEL SPEDOMETER BEAT KARBU

This video provides a tutorial on how to replace the speedometer cable on a Honda Beat Carburetor motorcycle yourself. Here's a summary of the steps shown in the video: Preparation & Initial Disassembly: Remove the right and left mirrors using a size 14 wrench [00:27]. Remove the top end of the old speedometer cable connected to the speedometer panel by turning the threaded part [03:04], and remove the bottom end of the cable connected to the gearbox on the front axle by prying it open with a screwdriver [01:09]. Remove the license plate holder using a T-spanner [01:17]. Remove the bolts securing the front body cover (shield) and headlight housing using a Phillips screwdriver [01:38], then remove the cover to expose the cable routing. New Cable Installation & Testing: Insert the new speedometer cable by following the original metal bracket's path to ensure the wires are durable, prevent kinks, or breaks [02:42]. Install and tighten the upper end of the cable thread to the speedometer panel [03:04]. Perform an initial test by manually rotating the cable wire to ensure the speedometer needle moves [03:38]. Insert the lower end of the cable into the front wheel gearbox hole until it locks into place [04:00]. Test again by turning the front wheel directly to ensure the speedometer needle rises normally as the wheel rotates [04:30]. Reassembly: Reinstall the front cover and headlight housing to their proper mountings [04:51]. Reinstall all body bolts, license plate brackets, and right and left mirrors until tightened [05:27]. Tool/spare part purchase link 👇 TEKIRO 10mm T-Wrench https://s.shopee.co.id/5fmf96imYf Plus screwdriver https://s.shopee.co.id/50WyLzGrB9 Speedometer cable https://s.shopee.co.id/5q65Lf2tnf