Amazing Manufacturing Process of Truck Battery Charger | Complete Production of Battery Charger

Thanks for Your support and Love. As a rule of thumb your battery charger should be a minimum of 10% of the Ah rating of the battery. e.g A 100Ah battery would require a 10 Amp charger as a minimum. To prevent overcharging you should keep the charger size to within 20% of the total capacity. You can charge car battery without removing it. Just be sure to connect the positive (red) wire first and be sure that your car charger has the correct settings before you connect to the battery. As far as the car is concerned, all that happens when you connect the charger is that the voltage “supplied by the battery” goes up a few volts. Amazing Manufacturing Process of Truck Battery Charger | Complete Production of Battery Charger If your car does start, let it run for a few minutes to help charge the battery further. Unhook the clamps in the reverse order of how you put them on. Be sure to drive your car for about 30 minutes before stopping again so the battery can continue to charge. Otherwise, you might need another jump start. A basic charger usually charges at around 2 amps - and so needs 24 hours to deliver the 48 amps needed to fully charge a flat, 48 amp hour battery. But there is a wide range of chargers with different charge rates on the market - from 2 to 10 amps. The higher the charge output, the faster a flat battery is recharged. In this video you can see how to make battery charger. It can be name as truck battery charger. The battery in your car can die within as little as two weeks when unused. When the car isn't regularly being used, the battery doesn't have a chance to recharge, leading to a dead battery. #truckbatterycharger #makingbatterycharger #batterychargermanufacturing #wonderingskills