Let's tweak the Sovol SV08

This video brought to you by PCBWay. PCBWay provides pcb, cnc and 3d printing services. WEBSITE HERE ▶ www.pcbway.com SIGNUP HERE ▶ https://pcbway.com/g/23pb5f Sovol SV08 Purchase here (Affiliate) http://shrsl.com/4s3rd In this video we go over how to improve the Sovol SV08 inductive probe, and how to swap out the fan that runs all the time and is far to loud!!! I also share my PETG, and PLA settings. All settings and changes to the printer.cfg are below. Enclosures if you want to print one: Credit to 3DprintMyLife https://www.printables.com/model/9597... Credit to Nadir for the work on this enclosure: https://www.printables.com/model/8793... Inductive probe changes: Edit your printer.cfg and add this, you will also comment out some parts. # = commenting out a section. Around line 67 [probe] pin: extra_mcu:PB6 x_offset: -17 y_offset: 10 ##z_offset : 0 speed: 10 #15.0 - I slowed this down speed: 5.0. samples: 3 #2 - increase in samples sample_retract_dist: 5 #2.0 - increased retraction lift_speed: 25 #50 - slowed down lift speed samples_result: median #average - changed samples_tolerance: 0.016 samples_tolerance_retries: 5 #2 - increased tolerance retries Fan Mod and Fan settings: Noctua Fan 24v 40x10mm https://www.amazon.com/dp/B0CN39MCPL?... Edit your printer.cfg and add this, you will also comment out what I have below in your printer.cfg - # = commenting out a section. This should be around line 375 ##[fan_generic fan3] # exhaust fan ##pin: PA2 ##max_power: 1.0 [temperature_fan fan3] pin: PA1 kick_start_time: 0.5 max_power: 1.0 min_temp: 0 max_temp: 90 hardware_pwm: true target_temp: 60 sensor_type: temperature_host max_speed: 1.0 min_speed: 0.1 control: pid pid_Kp: 2.0 ;40 pid_Ki: 5.0 ;0.2 pid_Kd: 0.5 ;0.1 pid_deriv_time: 2.0 Orca Slicer settings: For PLA - use the SOVOL base and change the following Flow Ratio I went up to .99 from .98 Flow Speed set to 21 Temp I have at 220, 218 - depending on PLA your using this may change a bit - I was using VoxelPLA+ for this testing. Pressure Advance - you can turn this on, start with .05 Also experimented with under Advanced: enable wipe while retracting PETG Under overrides: Enable length = 0.5 Enable Z hop = 0.4 Nozzle temp 240, 235 to start Flow Ratio = .95 Flow Speed = 15 to start - if using a high speed PETG you can try 18-21 First layer speed I have down to 30mm First layer infill I have down to 70-80mm