XYZ DaVinci 1 0A with Repetier 0.92 Bed Leveling technique

levelling the print bed can be very tricky. It took me a while to fully understand which adjustment screws affected which numbers. ┌─────────────┐ │4.....+..................-.....1│ │.......C.................A......│ │.......-...................+......│ │...................................│ │3.............+B-............2│ └─────────────┘ This very bad drawing shows the way I identify the adjustment controls and the autolevel result numbers. This is what I use the controls to adjust. Control A (Positive) + direction moves point 1 UP and point 3 DOWN Control A (Negative) - direction moves point 1 DOWN and point 3 UP Control B (Positive) + direction moves point 2 AND 3 UP and point 1 AND 4 DOWN a little Control B (Negative) - direction moves point 2 AND 3 DOWN and point 1 AND 4 UP a little Control C (Positive) + direction moves point 4 UP and point 2 DOWN Control C (Negative) - direction moves point 4 DOWN and point 2 UP Control A AND C (Positive) + direction by the SAME AMOUNT moves point 1 AND 4 UP and point 2 AND 3 DOWN Control A AND C (Negative) - direction by the SAME AMOUNT moves point 1 AND 4 DOWN and point 2 AND 3 UP Control A, B AND C (Positive) + direction by the SAME AMOUNT moves ALL points UP Control A, B AND C (Negative) - direction by the SAME AMOUNT moves ALL points DOWN Here are my original numbers and how I'd plan to get started. point 1 = 1.602 point 2 = 1.456 point 3 = 1.365 Control C to bring point 2 and close to point 3 Control A and C together to bring point 1 close to point 2 and 3 All controls together to get to the target number If you have any questions about this just let me know and I'll try to help. Enjoy :)