KingTech K142 G4 Turbine - Part 3 - Build a test stand and some test runs (4K)

Welcome to the first test run my shiny new KingTech K-142 G4 Turbine! I'm pretty new to making videos, so please let me have your comments if you think there are areas for improvement - I'm sure there are ! In this video we run through; 0:00 Introduction and welcome! 0:44 Build the test stand - part 1 1:28 3D Print the UAT holder 1:59 Build the test stand - part 2 2:29 Finished test stand ! 2:48 First RUN UP ! 5:56 Second RUN UP ! If you are interested in this content, please subscribe and like the video, it will really help motivate me to go and make some more videos in the freezing cold garage :) This is a series of videos on my KingTech turbine, check them out ! KingTech K142 G4 Turbine - Part 1 - Unboxing new turbine and quick review (4K) -    • KingTech K142 G4 Turbine - Part 1 - Unboxi...   KingTech K142 G4 Turbine - Part 2 - Setup for Futaba and RCLEARN tutorial (4K) -    • KingTech K142 G4 Turbine - Part 2 - Setup ...   KingTech K142 G4 Turbine - Part 3 - Build a test stand and some test runs (4K) -    • KingTech K142 G4 Turbine - Part 3 - Build ...   KingTech K142 G4 Turbine - Part 4 - Review of ECU/DRM default settings (4K) -    • KingTech K142 G4 Turbine - Part 4 - Review...   KingTech G4 Turbine - Part 5 - Setup of Failsafe Mode (on Futaba 18MZ) -    • KingTech G4 Turbine - Part 5 - Setup of Fa...   KingTech G4 Turbine - Part 6 - WOT NO FAILSAFE CODE ?? -    • KingTech G4 Turbine - Part 6 - WOT NO FAIL...   This is also part of my TopRC Model Odyssey build - my first RC Jet Build! Please checkout the playlist here;    • TopRC Odyssey Sports Jet Build Series   #KingTech '#K142 Music: https://www.bensound.com