HF on your VHF / UHF SDR RT2832 dongle (A simple upconverter)
If your RTL2832 dongle only tunes VHF/UHF, don't despair. You can use it to hear 3.5 and 7 MHz amateur signals (and more!) on it with good results. Contents 0:00 Introduction 1:20 Need for upconverter and description 4:35 Inside view 6:34 Circuit and description 10:46 In use demonstration 21:38 Books PS: If you liked this video please consider supporting Amateur Radio VK3YE by: Subscribing on YouTube Checking my books page at https://books.vk3ye.com Shopping on Amazon via: https://amzn.to/3iiDQXv, or Shopping on eBay via: https://ebay.us/i9DuWP (then if you buy something I'll get a small commission at no cost to you)
▶︎
#175: Filter functions in an HF Upconverter used with RTL-SDR Dongle Receiver
▶︎
Electronics on the Floor: VHF transmitters from crystal oscillator modules
▶︎
RTL-SDR Multiband antenna
▶︎
What can you hear on a VHF 'crystal set'?
▶︎
#174: Using a mixer to listen to HF, shortwave, ham, etc. on RTL-SDR dongle
▶︎
Collins Radio Was the Best. So Why Did It Fail?
▶︎
The Ham Radio: Where Did 750,000 Operators Go?
▶︎
Turn your HF transceiver in to a VHF/UHF radio
▶︎
SDR-RTL DONGLE SHORTWAVE UP CONVERTER
▶︎
10 Common Mistakes Made With Software Defined Radio
▶︎
Receiving 10 GHz EME with a small dish and LNB
▶︎
Howto Interface Your Radio with your SDR and Share an Antenna
▶︎
Random Wire End Fed HF Antennas. Is this a sensible choice for an All-Band Antenna?
▶︎
Ham Radio - Build your own QRPp CW transmitter
▶︎
Simple two metre to VHF airband receiving converter
▶︎
RTL SDR HF Helper improves reception
▶︎
#286 How does Software Defined Radio (SDR) work under the Hood? SDR Tutorial
▶︎
#228: Radio Fun: Michigan Mighty Mite CW transmitter and a low pass filter
▶︎
Anatomy of a homebrew 40m superhet receiver
▶︎