Clean Me Light is Solid - Now What! | Breville Barista Express

Amazon link: As an Amazon Associate I earn from qualifying purchases. Descaler (2 Uses Per Bottle) - https://amzn.to/2QaZcN0 Water Filter - https://amzn.to/2KGiMgI How To: 1. Check if the ‘CLEAN / DESCALE’ light is illuminated (solid on), descaling is required. Add Descaling Solution to water tank (Follow cleaning instruction) 2. Press and hold the 2-CUP button and then press and hold the POWER button simultaneously to enter the Descale mode. The unit will heat up as part of commencing the descaling action, during the heating processes the POWER button should flash continuously. The machine will indicate it is ready for descaling when the POWER button, 1 CUP button, CLEAN/DESCALE indicator and HOT WATER/ STEAM indicator are all illuminated (solid on). Descaling the coffee component 4. Press the 1-CUP button to start the descaling for the coffee component of the machine. Descaling coffee component takes approximately 25 seconds. The 1CUP button should flash continuously and remain constant once the descaling process has finished. To terminate the descaling within 25 seconds, press the 1 CUP button again. Descale the Steam and hot water components Descaling steam and hot water takes approximately 13 seconds and 8 seconds respectively. Descaling can be terminated prematurely by turning the steam dial to STANDBY. 5. Descale Steam component by turning the steam dial RIGHT towards the icon. 6. Descale Hot water component by turning the steam dial to the LEFT towards the icon. Repeat processes to complete descaling After the above processes about half (17 fl. Oz / 0.5L) of the descale solution should be left in the water tank. 7. Repeat steps 4-6 above to complete the descaling process to empty the solution in the tank. Descaling Solution Rinse 8. After descaling, remove the water tank and rinse thoroughly then refill with fresh cold water to the maximum capacity (68 fl. oz / 2L) and repeat steps 4-6 to further cleanse the machine of any residue of the cleaning solution thoroughly. 9. Press ‘POWER’ to quit the descaling process. This will be indicated by the LED lights switching off.