Sawmill Laser Line Changes Everything | Placement and Setup

Welcome back to the channel folks. On today's episode I've got something new to show you that is going to change everything. I'm unboxing and installing a laser line on my sawmill today which will eliminate the guesswork involved in making saw cuts. If you've seen my other videos you know that I often have to estimate where the first cut on a log should go to ensure I do not waste material. Sometimes this estimate isn't very good and I end up cutting too little or too much wood. This results in wasted time and lumber. With this new laser line I no longer will be guessing where my first cut will be as the laser projects a line right where the blade will cut. The horizontal green laser line is bolted to the end of my sawmill and powered with a simple battery pack (two AAA batteries) with a switch built in. This laser is small and compact with high-end quality that allows it to be used in commercial sawmill operations. Check out the placement of this laser line on my 2017 Woodland Mills HM130 and the relatively easy installation process. This opens up a whole new opportunity for me to boost my efficiency at my sawmill and I'm looking forward to it. Glad all you folks are along for the ride. Here we go! All laser parts shown in this video came from the following: (Green Line Generator Laser Module) AGLL2: 20mw https://www.apinex.com/ret2/agll25an.... (3 Volt Power Supply Kit) PS-3: https://www.apinex.com/ret2/ps3an.html (Mounting bracket for laser module) BRH 20mm - https://www.apinex.com/ret2/brhan.html Sawmill shown in this video: 2017 Woodland Mills HM130 #sawmill #sawmillvideos #sawmilllaser