Installing Headers: Long Tube Style
Hopefully this is my last time in the engine bay for a while. This vid goes over installing long tube headers without removing or replacing the starter. I'm also installing new motor/trans mounts, and my DIY solid steering shaft.
▶︎
Long Tube vs Short Tube Headers | The Technical Differences
▶︎
Does a Performance Exhaust Increase Horsepower? (How to Install an Exhaust System)
▶︎
Mustang Fuel Tank Pump In Tank Style 1983-1997 Installation
▶︎
Delete Your Foxbody Mustang Emissions!! And Gain HORSEPOWER!! Foxbody Engine Swap Part 6
▶︎
Easy LS Cam swap without pulling the heads!
▶︎
The Worst Car I Drove on Top Gear – Is It That Bad?
▶︎
Things every car guy should know about engines
▶︎
I Built a 500HP Escalade Engine Using only TEMU Parts
▶︎
Edelbrock Intake Manifold Dyno Test Single Vs Dual + Air Gap Vs Regular
▶︎
IDIOTS AT WORK Mechanic Edition | Part 2
▶︎
1986-1993 Mustang 5.0 Resto Idle Air Control Adjuster - Review & Install
▶︎
How to properly adjust your clutch cable!
▶︎
How To Install the Best Fox Body Front Suspension
▶︎
Top 10 Muscle Car Engine Upgrades Under $500 That REALLY Work
▶︎
Flat Tappet vs Roller Cam - The Factory 302/5.0 SBF
▶︎
Foxbody wire tuck! FREE MOD, AMAZING RESULTS!
▶︎
Foxbody Mustang Door Hinge Rebuild Kit | 1982-1993 Mustang Installation Guide
▶︎
Setting Ignition Timing on a Fox Body Mustang | This Changes Everything DIY
▶︎
Parallel vs. Sequential vs. Compound - Twin Turbo systems explained - Boost School #11
▶︎