Easy and Fast E46 M3 Coolant Flush

This is a quick and easy coolant flush guide for the E46 M3. Instead of removing the lower radiator hose (which is very troublesome) I removed the temp sensor from the lower hose to open the system. I also went a step further and removed the engine block bolt to drain the coolant from the block. Once that was opened, I added water to the expansion take to flush out any remaining coolant. You want to perform this every 2 years to prevent corrision, blockages or damage to the engine or cooling system. I did not jack up the car, but I did use a set of Rhino ramps, which can be found here. You should have a set. - http://amzn.to/14VR8hW I used the following DIY's as a guide when I made this video: http://blankowski.com/Cars/m3_coolant... http://m3forum.net/m3forum/showthread... http://www.m3forum.net/m3forum/showth... Note: THE USE OF THIS DIY IS FOR YOUR REFERENCE ONLY. I DISCLAIM ALL LIABILITY FOR DIRECT, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OR INJURIES THAT RESULT FROM ANY USE OF THE EXAMPLES, INSTRUCTIONS OR OTHER INFORMATION IN THIS DIY.