How to add GPS to an Arduino & Make a Simple Navigation Project

🔗 The full guide : https://core-electronics.com.au/guide... In this video, we will be learning how to add a GPS receiver module to an Arduino. We will be taking a look at how GPS works, and how to wire up and code your project to get coordinates, as a final step, we will be making a short and sweet GPS project - a small device that tracks a target location and uses our current location to display the distance and direction to that target, allowing you to navigate there from anywhere on the surface of the earth. 🔧🔨🧰 Hardware featured in this guide: NEO-6M GPS Module: https://core-electronics.com.au/catal... Arduino: https://core-electronics.com.au/ardui... 💡❓ If you have any questions about this content or want to share a project you're working on head over to our maker forum: http://coreelec.io/forum 0:00 What we are doing 0:23 How GPS works 1:56 What you will need 2:21 Connecting the GPS 4:14 Reading the raw GPS UART output 8:37 Using a GPS library 10:44 Project: DIY navigation device 🌏🦘 Core Electronics is located in the heart of Newcastle, Australia. We're powered by makers, for makers. Drop by if you are looking for: • Raspberry Pi https://core-electronics.com.au/raspb... • Arduino https://core-electronics.com.au/ardui... • Sparkfun https://core-electronics.com.au/brand... • Adafruit https://core-electronics.com.au/brand... • Pololu https://core-electronics.com.au/brand... • DFRobot https://core-electronics.com.au/brand... The following trademarks are owned by Core Electronics Pty Ltd: "Core Electronics" and the Core Electronics logo "Makerverse" and the Makerverse logo "PiicoDev" and the PiicoDev logo "GlowBit" and the GlowBit logo